FlushNut™ Wrench

Instructions For Use

To tighten FlushNuts:

1. Once the FlushNut is finger tightened into place, slide the grooved side of the wrench down the tubing, engaging the nut.
2. Turn the wrench clockwise until the fitting is sufficiently tightened.

To loosen FlushNuts:

1. Slide the grooved side of the wrench down the tubing, engaging theFlushNut.
2. Turn counter-clockwise until the fitting is loosened.

Please Note: If the tubing is formed into a loop, or if it is shorter than the FlushNut Wrench, the tubing may twist around the wrench while tightening and loosening the nut. To prevent this, turn the wrench 1/2 turn, remove the wrench and repeat above instructions.